The respective role of oxygen and water vapor on the tribology of hydrogenated diamond-like carbon coatings

Abstract

The tribological behavior of diamond-like carbon coatings (DLC) strongly depends on the chemical nature of the test environment. The present study proposes to explore the influence of water vapor and oxygen on the friction behavior of a hydrogenated DLC coating exhibiting ultralow friction in ultrahigh vacuum (friction coefficient below 0.01). Using a UHV tribometer, reciprocating pin-on-flat friction tests were performed in progressively increasing or decreasing partial pressures of pure oxygen and pure water vapor. The maximum gaseous pressures of oxygen and water vapor were 60 hPa and 25 hPa (1 hPa = 100 Pa), respectively, the second value corresponding to a relative humidity (RH) of 100% at room temperature. It was found that, for the pressure range explored, oxygen does not change the ultralow friction behavior of DLC observed in UHV. Conversely, water vapor drastically changes the friction coefficient at pressures above 0.5 hPa (RH = 2%), from about 0.01 to more than 0.1. Electron energy loss spectroscopy and in situ Auger electron spectroscopy have been performed to elucidate the friction mechanisms responsible for the tribological behaviors observed with the two different gaseous environments. In all cases no significant oxidation has been observed either inside the wear scars or in the wear debris particles. Ultralow friction is systematically associated with a homogeneous carbon-based transfer film. The higher friction observed at partial pressure of water vapor higher than 0.5 hPa, is associated with a thinner transfer film. Consequently friction seems to be controlled by the transfer film whose kinetics of formation strongly depends on the partial pressure of water vapor. © J.C. Baltzer AG, Science Publishers.